Název:
Měření komponent ručních palných zbraní - vliv technologie broušení
Překlad názvu:
Measurement of small arms components - influence of grinding technology
Autoři:
Havlík, Daniel ; Kalivoda, Milan (oponent) ; Polzer, Aleš (vedoucí práce) Typ dokumentu: Diplomové práce
Rok:
2023
Jazyk:
cze
Nakladatel: Vysoké učení technické v Brně. Fakulta strojního inženýrství
Abstrakt: [cze][eng]
Tato diplomová práce se zaobírá problematikou měření parametrů textury povrchu komponentu ruční palné zbraně při aplikaci na kohout revolveru. Měřená součást byla vyráběna třískovým obráběním, konkrétně technologií broušení. V práci byl popsán návrh a provedení experimentu zaměřený na sledování vlivu změn technologických podmínek (řezných podmínek) na texturu povrchu součásti.
This master thesis deals with the problem of measuring the surface texture parameters of a small arms component when applied to the hammer of a revolver. The measured component was manufactured by chip machining, specifically by grinding technology. The paper describes the design and execution of an experiment aimed at monitoring the effect of changes in technological conditions (cutting conditions) on the surface texture of the component.
Klíčová slova:
broušení; drsnost povrchu; kohout revolveru; obrábění; plošná metoda; profilová metoda; součást; textura povrchu; component; grinding; hammer of a revolver; machining; profile method; surface method; surface roughness; surface texture
Instituce: Vysoké učení technické v Brně
(web)
Informace o dostupnosti dokumentu:
Plný text je dostupný v Digitální knihovně VUT. Původní záznam: http://hdl.handle.net/11012/210563